Difference between revisions of "Sample design"
Jump to navigation
Jump to search
Line 1: | Line 1: | ||
− | [[Category: | + | [[Category:PlanWise]] |
+ | [[Category:StandWise]] | ||
+ | [[Category:RegWise]] | ||
− | [[:User's guide to | + | [[:User's guide to PlanWise]] |
Prior to inventory, a "stratification" needs to be done. This is valid also in a complete inventory (when all stands in the analysis area are included), since some general inventory parameters are set in this part. Considering cost-efficiency, the inventory is commonly based on a two-stage sampling procedure. Here, this starts with selecting the imported stand register of interest, i.e. the analysis area to be in-field inventoried by plotwise sampling in PPS-sampled stands. | Prior to inventory, a "stratification" needs to be done. This is valid also in a complete inventory (when all stands in the analysis area are included), since some general inventory parameters are set in this part. Considering cost-efficiency, the inventory is commonly based on a two-stage sampling procedure. Here, this starts with selecting the imported stand register of interest, i.e. the analysis area to be in-field inventoried by plotwise sampling in PPS-sampled stands. | ||
===Instruction=== | ===Instruction=== | ||
− | # In | + | # In PlanWise, open an existing project or create a new one. |
− | # From the top menu " | + | # From the top menu "Data Management" (Datahantering), select "Sample Design" (Stickprovsdesign). |
# Click on "Create New". | # Click on "Create New". | ||
# A wizard will guide you through the setup of a sample design. The steps are explained in more detail below. In short: | # A wizard will guide you through the setup of a sample design. The steps are explained in more detail below. In short: |